# Option B: bought hardware in the mounted model

Generated by `hardware_v1.py` from the same geometry as the printed parts, at hip 30°. One row per type; every instance is in `robot_option_B_mounted.step` under `hardware/`.

| Qty | Part | Where |
| --- | --- | --- |
| 4 | 625ZZ 5x16x5 | bone, pivot end (2); bone, shin end (2) |
| 4 | 688ZZ 8x16x5 | shin, at the knee |
| 4 | M2.5 M-F hex standoff 5 AF x 11 | Duo S to the deck: stud through the Duo S into the deck insert, the carrier rests on top |
| 4 | M2.5 heat-set 3.9x4 | deck boss under the Duo S |
| 4 | M3 heat-set 4.6x4 (short) | shin outer face (hole 5 deep) |
| 34 | M3 heat-set 4.6x5.7 | ear plate, pressed in from its inner face (8); frame plate, pressed in from below (4); frame corner post, from the top (4); frame deck post, from the top (4); deck boss under the carrier (2); base rear wall (2); thigh, radial hole at the knee (2); wheel rim, from its outer face (8) |
| 12 | M3x18 ISO 4762 | servo ear, from outside the side wall into the ear plate (8); sensor cap and mount into the shin (4) |
| 4 | M3x45 ISO 4762 | base to frame, from underneath |
| 8 | M3x5 ISO 4762 | motor cover to the rotor face (check the rotor's thread depth) |
| 4 | M3x50 ISO 4762 | cover and deck into the frame's corner posts |
| 6 | M3x6 ISO 4762 | carrier H1/H2 into the deck bosses (2); thigh to the clamp arm (4) |
| 2 | M3x8 ISO 4026 | on the knee shaft's flat |
| 24 | M3x8 ISO 4762 | deck into the frame's deck posts (4); battery door into the base (2); 25T clamp arm onto the servo spline (comes with the arm) (2); GM4108H base to the shin, heads in the inner-face counterbores (8); motor cover to the wheel rim (8) |
| 4 | M5 heat-set 7x8 | base pivot boss (2); shin, from the face toward the body (2) |
| 10 | M5 washer 10x1 | between the boss and the bone (2); in the bone's lip hole (4); under the pin screw's head (2); between the bone and the shin (2) |
| 2 | M5x12 ISO 7380 | bone pivot into the base boss |
| 2 | M5x14 ISO 7380 | bone to shin, from the thigh side |
| 2 | diametric magnet 6x2.5 | in the magnet holder |

134 hardware instances. Not drawn: the 25T arm's two clamp screws (they come with the arm), the E-stop's nut, velcro straps, and the cover's accessory nuts (only when you add something).
